|
|
METALON C2
is distinctly different from any of the so-called "additives",
which only try to improve the 'film strength' of lubricants.
In contrast, METALON C2 is a Metal Surface Treatment.
METALON combines chemically with the surfaces of bearing
metals, (ferrous and non-ferrous), to form a microscopic monomolecular
shield.
Logically, wear or material removal occurs when oil
or grease films separate momentarily and metal is allowed
to contact metal. The result: instant friction and
removal of small amounts of material every time. This process,
which is more or less frequent, (depending on the design of
the equipment), adversely affects the equipment life and costly
downtime for repairs.
Therefore, any additive that claims to improve 'lubrication
film strength' is only marginally effective. Since
lubrication films do separate and expose bare metal under
load, any improvement is momentary. Costly wear and friction
occur until the film is re-established.
With METALON chemically bonded in place, metal surfaces
are protected against devastating 'cold starts'. Every time
the lubrication film separates, the metal contact surfaces
burnish (polish) each other, instead of being ground away
continuously. This burnishing action 'levels' the high spots
and ridges, virtually increasing the contact surface area.
METALON arrests excessive wear and the significant
reduction of friction creates energy savings.
The uniqueness of METALON C2 permits its use in a wide
range of Industrial Applications. When blended with a gas-oil
mixture for two-stroke power saws, Dyno Tests showed METALON
C2 increased the power by 10%, eliminating vapour lock
and reduced vibration substantially. When applied to the most
demanding Hydraulic Systems, such as; Hydraulic Cranes, Self-Loaders,
Hydraulic Blenders and Pumping units, oil temperature drops
of 50°F are commonplace.
Since METALON C2 contains no solvents or detergents,
it performs extremely well in Compressors and other non-filtered
systems. It is used with cutting, machining and metal-forming
oils, resulting in faster production, smoother finished parts
and greater tool life.
An initial METALON C2 treatment is 5% by volume (10%
in severe applications, such as vibrators, compactors, areas
of constant high heat, etc.) Future treatments of 2.5% by
volume only in areas where oil is changed regularly. All "sealed
systems" (transmissions, hydraulics) require only one
application, unless the oil is lost or changed. Then, 2.5%
is applied to the new oil to maintain the chemical reservoir.
| DESCRIPTION |
ASTM METHOD |
TEST RESULTS |
| Pour Point |
D-97 |
-60°F (-34°C) |
| Viscosity, @ 100°F |
D-445 |
65.7 SUS, 11.92 cSt |
| Specific Gravity
@ 60°F |
D-1298 |
0.9692 |
| Foaming Characteristics |
D-892 |
0, 0, 0 |
| Water Content % by
Volume |
D-96 |
0.00% |
| Ash Content % by
Weight |
D-482 |
0.01% |
NOTE: The information and data presented herein are
based on tests, reports, and research we believe to be accurate
and reliable. The information and data are provided without
warranty, guarantee or liability on our part, and are therefore,
provided to customers for their own investigation, verification,
and consideration. |
|
